SWYCH FOR
CAR WASHES
Wire a MD1/2 microPLC into your existing wash bay — wireless fault and level alerts without a new control system.
THE OLD WAY
- 01.Old wash bays have no remote visibility — you only find out about problems when a customer complains.
- 02.Running data cable between bays and the office means cutting into concrete and conduit.
- 03.Stand-alone sensors give alerts but can't talk to your existing PLC or BMS.
THE SWYCH WAY
- 01.Drop-in MD1/2 microPLC: Wire into your existing fault relays, float switches, or pressure transducers and get wireless visibility instantly.
- 02.Modbus I/O: Read soap tank levels, pit floats, and pump pressures via Modbus RTU sensors — relay data wirelessly back to the office.
- 03.Relay outputs: Remotely reset a tripped pump or trigger an alarm from your phone or HMI.
- 04.No new control system needed: The MD1/2 microPLC slots alongside what you already have — just adds the wireless data bridge.
DEPLOYMENT SCENARIOS
🧼
Soap Level Sensing
Connect a Modbus level sensor to the chemical tank — get low-level alerts before you run dry.
⚠️
Pit High-Level Alarm
Wire a float switch to a MD1/2 microPLC digital input for overflow warnings.
🧹
Vacuum Run Hours
Read a run-time counter via Modbus to schedule maintenance intervals.
📉
Pump Pressure Drop
Connect a 4-20 mA pressure transducer and get alerts when pressure falls.
Ready to upgrade your infrastructure?
Deploy a pilot system in under 2 hours. minimal downtime. Maximum efficiency.